Armour Detail Supply Phobic Coating

PRO Coating Topper

Think of ADS Phobic the same way you think about EXO. It's the second layer that goes on top of your PRO Quartz Coating.

There are three reasons to use it:

• More slickness and better water behavior
• It acts as a sacrificial layer, taking the abuse instead of your main coating.
• Added gloss and depth

You can use Phobic by itself as a budget option. I don't recommend that. If you're going standalone, I'd rather see you run CSL. In my mind, Phobic is a topper. It exists to protect and enhance a pro coating underneath.

This is how it's recommended to apply.

1. Prime your applicator or short nap towel with 10 to 15 sprays to start. After that, 3 to 5 sprays per panel is plenty. Less is more.
2. Work one panel at a time using overlapping circular motions. Let it sit for about 30 to 60 seconds, depending on temperature and humidity. You're looking for light haze or small sweat beads.
3. Level the coating with a plush towel using light circular passes. Check for streaks or high spots and clean them up as you go.
4. Flip to a fresh side of your leveling towel every other panel. The application towel can be used for the whole car.
5. When you're done, remove the spray head, rinse it out, seal the bottle, and store it in a cool, dry place.

PHOBIC is designed as a single-layer coating. You can layer it if you want. Just give it a few minutes between layers, and you'll get the best results.