I had this custom made specifically to hold the Kranzle K1322TS or K1622TS pressure washer.  It's so pretty, it's almost a shame to put anything on it.  

• Comes w/ 2 Mounting Brackets and Shelf
• You will need to supply mounting screws to attach to the wall.  They are not included.
  
• Made of T304 Stainless Steel
  
• 18" Wide x 8" Deep

• Optional Hardware
• 2 - 3/4" T-304 anti-vibration clamps
• 2 - 5/8" T-304 anti-vibration clamps
• 2 - 3/8" T-304 anti-vibration clamps
• 6 - 5/8" Stainless Hex Bolts
• 6 - Wing Nuts

The optional hardware add-on includes mounting hardware and snug-fit anti-vibration clamps to strap the pressure washer down, route the power cord, and hold the jumper hose in place.

Note, I'm sending this without any pre-drilled holes.  The holes you see in the photo are 3/16" that I drilled with a basic metal bit.  You'll want to lay out your pressure washer and mark the holes with a sharpie.  Make sure you leave enough room between the wall and the unloader valve (red knob) to operate.

• I drilled both holes 4 5/8" from the left edge of the shelf.
• Back hole is 2 3/8" and the front hole is 6 1/8" off the back wall.

Comes w/ 2 Mounting Brackets and Shelf

This item is shipped from our warehouse at OGHQ in Lady Lake, FL. Shipping costs calculated at checkout.

ETA Information: